Reptile Forum, Reptile Classifieds - CaptiveBred

[mickded]

If you have a viv with too much humidity, (glass running with water) if you have glass sliding doors, there is a simple cure. Go to your local DIY store, and buy a small piece of clear perspex, remove one of your glass doors, and draw around it on the perspex, cut the perspex to size, be careful not to crack the perspex when you saw it. Now make yourself a paper grid of lines, tape the paper grid onto the perspex, and where all the lines meet, drill a series of holes, dont make them too near the bottom, or you may have crickets on the loose. Now fit the perspex into the same runner as your remaining glass door, and there you have it, much more air circulation. If by any chance your glass runners are to tight to the glass and there is not enough room for the perspex to slide past the remaining glass door, just fix a narrow strip of wood to the perspex edge where it meets the remaining glass door, trim to fit the runner top and bottom, and fit to other glass runner.
Regards.
mickded.